Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Charging System: Service and Repair
86.10.02 Alternator - KV6
Remove
1. Disconnect battery earth lead.
2. Remove top arm.
3. Using a 3/8 inch square drive socket bar, raise ancillary drive belt tensioner and release drive belt from alternator pulley.
4. Release alternator battery lead terminal cover, loosen terminal nut and disconnect lead from terminal
5. Disconnect alternator multiplug.
6. Remove lower bolt and upper nut and bolt securing alternator to front mounting plate.
7. Remove alternator.
Refit
1. Position alternator to front mounting plate.
2. Fit bolt and nut and bolt securing alternator to front mounting plate and tighten to 45 Nm (33 lbf.ft).
3. Using a 3/8 inch square drive socket bar, raise ancillary drive belt tensioner and fit drive belt to pulleys.
4. Connect alternator multiplug.
5. Position battery cable to alternator, tighten nut to 10 Nm (7.5 lbf.ft) and position terminal cover.
6. Fit top arm.
7. Connect battery earth lead.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.