Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Land Rover Freelander SEFACTORY OEM SERVICE PROCEDURE
Automatic Transmission DTCS
DTC INDEX
| DTC | Description |
|---|---|
| P0702 | Short circuit to battery |
| P0705 | Multiple signal or No signal |
| P0710 | Signal out of range |
| P0715 | No signal |
| P0720 | No signal |
| P0730 | Mechanical failure |
| P0731 | Out of range - Incorrect ratio when 1st gear selected |
| P0732 | Out of range - Incorrect ratio when 2nd gear selected |
| P0733 | Out of range - Incorrect ratio when 3rd gear selected |
| P0734 | Out of range - Incorrect ratio when 4th gear selected |
| P0735 | Out of range - Incorrect ratio when 1st gear selected |
| P0736 | Out of range |
| P0740 | Out of range - Abnormal lock-up condition |
| P0743 | Open circuit or short circuit to earth/battery |
| P0748 | Open circuit or short circuit to earth/battery |
| P0753 | Open circuit or short circuit to earth/battery |
| P0758 | Open circuit or short circuit to earth/battery |
| P0763 | Open circuit or short circuit to earth/battery |
| P0790 | Multiple signal |
| P1562 | Out of range |
| P1605 | Error flag set - Clear flag. Power was disconnected from EAT ECU before main relay opened. |
| P1715 | Open circuit |
| P1717 | Open circuit or short to earth/battery |
| P1718 | Open circuit or short to earth/battery |
| P1719 | Open circuit or short to earth/battery |
| P1748 | Open circuit or short to earth/battery |
| P1776 | Lack of engine response |
| P1785 | Open circuit or short circuit to earth/battery |
| P1786 | Open circuit or short circuit to earth/battery |
| P1787 | Open circuit or short circuit to earth/battery. |
| P1815 | Multiple signals/No signal |
| P1825 | Shift interlock ECU failure |
| P1840 | CAN Bus malfunction - No CAN messages or incorrect messages |
| P1841 | CAN Bus malfunction - No CAN messages or incorrect messages |
| P1842 | CAN bus malfunction - No CAN messages or incorrect/incompatible messages |
| P1843 | CAN Bus missing nodes detected - CAN bus malfunction - No CAN messages or incorrect messages |
| P1844 | Error flag set |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
