2004 Land Rover Freelander SEFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
Air Bag DCU Connector (C0256) Behind center console. See Figure .
Central Control Unit Connector (C0428) Behind passenger compartment fuse box. See Figure .
Central Control Unit Connector (C0429) Behind passenger compartment fuse box. See Figure .
Central Control Unit Connector (C0430) Behind passenger compartment fuse box. See Figure .
Cooling Fan Control Unit Connector (C0208) At left side of engine compartment. See Figure .
Cooling Fan Control Unit Connector (C0701) At left side of engine compartment. See Figure .
Cooling Fan Control Unit Connector (C1680) At left side of engine compartment. See Figure .
Cruise Control ECU Connector (C0239) Under right front seat. See Figure .
Electronic Automatic Transmission ECU Connector (C0932) Inside "E" box. See Figure .
Engine Control Module Connector (C0331) Inside "E" box. See Figure .
Engine Control Module Connector (C0332) Inside "E" box. See Figure .
Engine Control Module Connector (C0603) Inside "E" box. See Figure .
Engine Control Module Connector (C0604) Inside "E" box. See Figure .
Engine Control Module Connector (C0606) Inside "E" box. See Figure .
Engine Immobilization ECU Connector (C0052) Behind center of dash. See Figure .
ICE Interface Module Connector (C1897) Behind center console.
PDC ECU Connector (P7141) At right side of luggage compartment. See Figure .
Window Lift ECU Connector (C0341) Behind left side of dash. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.