2004 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE

Camshaft Position Sensor: Service and Repair



Sensor - Camshaft Position (CMP)

Service Repair No - 18.30.24

Remove
1. Disconnect battery earth lead.
2. Remove engine acoustic cover.

Factory service manual diagram




3. Release CMP multiplug from bracket and disconnect multiplug.

Factory service manual diagram




4. Remove bolt securing CMP sensor multiplug bracket and release CMP sensor lead from behind bracket.
5. Remove bolt securing CMP sensor to camshaft cover.
6. Remove CMP sensor and discard seal.

Refit
1. Clean CMP sensor and mating face.
2. Lubricate new seal with clean engine oil and fit to CMP sensor.
3. Position CMP sensor, fit and tighten bolt to 8 Nm (6 ft. lbs.).
4. Feed CMP sensor lead behind multiplug bracket, align bracket, fit bolt and tighten to 8 Nm (6 ft. lbs.).
5. Connect CMP sensor multiplug and secure to bracket.
6. Fit engine acoustic cover.
7. Connect battery earth lead.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.