Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Interface ECU - Cruise Control - KV6
Interface ECU - Cruise Control - KV6
Service repair no - 19.75.55
Remove
1. Slide RH front seat fully rearwards.
2. Remove 2 screws securing ECU cover.
3. Remove cover.
4. Release interface ECU from bracket disconnect multiplug and remove ECU.
Refit
1. Position ECU, connect multiplug and secure ECU to bracket.
2. Fit ECU cover and secure with screws.
3. Position seat to mid position.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.