Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Radiator Support: Service and Repair
Bonnet Locking Platform
In this procedure the bonnet locking platform reinforcement is also replaced in conjunction with the bonnet locking platform.
Remove
1. Disconnect battery earth lead.
2. Disconnect alternator.
3. Disconnect all ECUs.
4. Remove front bumper valance.
5. Remove radiator.
6. Remove both headlamp assemblies.
7. Remove horn.
8. Remove battery.
9. Remove air intake hose.
10. Remove bonnet lock.
11. Support bonnet in open position.
12. Remove bonnet stay.
Repair
1. Remove existing panel(s), prepare panel joint faces and install new panel(s) in accordance with Panel Replacement Procedure.
Refit
1. Fit bonnet stay.
2. Fit bonnet lock.
3. Fit air intake hose.
4. Fit battery. Do not connect earth lead.
5. Fit horn.
6. Fit both headlamp assemblies.
7. Fit radiator.
8. Fit front bumper valance.
9. Connect all ECUs.
10. Connect alternator.
11. Connect battery earth lead.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.