2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

Steering Geometry Adjustment: Check

  1. Check steering joints, suspension joints and wheel bearings for wear or free play. Adjust or repair as required.
  2. Ensure tire pressures are correct and vehicle is at correct ride height. See RIDING HEIGHTΒ . Roll vehicle backwards and forwards to relieve stresses in steering and suspension.
  3. NOTE: Only use 4-wheel alignment equipment recommended for use by manufacturer.
  4. Ensure that wheel alignment equipment is properly calibrated.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.