2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

Front - Toe In/Out: Check

  1. Ensure tire pressures are correct and vehicle is at correct ride height. See RIDING HEIGHTΒ .
  2. NOTE: Only use 4-wheel alignment equipment recommended for use by manufacturer.
  3. Roll vehicle backwards and forwards to relieve stresses in steering and suspension. Ensure that wheel alignment equipment is properly calibrated.
  4. Check and if necessary adjust wheel alignment (toe in/out). See SPECIFICATIONSΒ .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.