Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
Error Messages
- Three instrument panel warning lights may illuminate when steering column repairs are performed:
- Emergency Brake Assist (EBA)
- Dynamic Stability Control (DSC)
- Anti-lock Brakes (ABS)
- ERROR messages may be displayed on the message center and it may not be possible to achieve equal turns the steering wheel from lock-to-center-to-lock. See SPECIFICATIONSΒ .
- Several possible causes for these symptoms may be present:
- A NEW steering angle sensor requires calibration.
- The timing marks for aligning the steering wheel are not aligned. See appropriate STEERING COLUMN article.
- The steering wheel has been aligned to the incorrect timing mark.
- The track rod ends are incorrectly set.
- If ERROR messages are present, see TSB No. 57/01/02/NAS STEERING WHEEL ALIGNMENT DURING REPAIRS under TECHNICAL SERVICE BULLETINS.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
