Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
DSC System Warning Lamps
- HDC lamp
- Brake warning lamp
- Brake assist/brake warning lamp
- ABS warning lamp
- DSC warning/information lamp
The following table describes the warning lamps, their associated faults and system response.
| System Status | Hand Brake Warning Lamp | Brake Warning Lamp | ABS Lamp | DSC Lamp | HDC Lamp | Message Centre |
|---|---|---|---|---|---|---|
| Lamp check | On for 2 seconds | Amber for 1 second then red for 1 second | On for 2 seconds | On for 2 seconds | On for 2 seconds | |
| ECU under voltage | On, red and amber | On | On | Off | ||
| Hand brake On | On, red | Release park brake (when driving) | ||||
| Low brake fluid level | On, red | Check brake fluid | ||||
| Electric Brake Assist (EBA) failure) ABS & EBD available) | On, amber | Off | ||||
| ABS Failure (EBD available) | On, amber | On | On | Off | ||
| EBD failure | On, amber, or red | On | On | Off | ||
| DSC failure | On, amber, or red | On | On | Single gong 1st time failure occurs | ||
| HDC failure | On, amber or red | On | Off | HDC Inactive | ||
| DSC activity (including engine intervention) | flash 2 Hz | |||||
| ETC activity (brakes only) | ||||||
| DSC switched passive (TC function still available) | On | |||||
| ETC activity while DSC switched passive | On | |||||
| HDC switched on (not enabled or fading out) | On | |||||
| HDC switched on and enabled | flash 2 Hz | |||||
| HDC switched on and enabled | On | |||||
| HDC temporarily unavailable (brake overheat) | Off | HDC temp. Not available | ||||
| HDC switching off (due to high speed in high range) | Off | No HDC - slow down | ||||
| Driver attempt to switch on HDC at high speed in high range | Off | No HDC - slow down |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
