Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Radiator Cooling Fan Control Module: Service and Repair
Control Unit - Radiator Cooling Fan
Service Repair No - 26.25.43
Remove
1. Disconnect battery earth lead.
2. Release multiplugs from clips and disconnect 2 body harness multiplugs.
3. Disconnect multiplug from LH cooling fan and release harness from 4 retaining clips.
4. Disconnect multiplug from RH cooling fan and release harness from 2 retaining clips.
5. Remove screw securing control unit.
6. Release control unit from fan cowl.
Refit
1. Carefully position control unit in cowl and secure with screw.
2. Connect body harness multiplugs and secure to cowl.
3. Secure LH and RH harness to retaining clips and connect multiplugs.
4. Connect battery earth lead.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
