Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Drive Belt: Service and Repair
86.10.03 Ancillary Drive Belt
Remove
1. Disconnect battery earth lead.
2. Remove top arm. 12.45.06 Arm Assembly-Engine Mounting RH
3. Remove 4 bolts securing engine mounting bracket to engine front plate and remove bracket.
4. Using a 3/8" square drive socket bar, raise ancillary drive belt tensioner and release drive belt from alternator pulley.
5. Release and remove ancillary drive belt from remaining pulleys.
Refit
1. Clean pulley 'V's and tensioner pulley running surface.
NOTE: Examine drive belt for signs of wear. A drive belt with cracked ribs is acceptable. A drive belt that has loose or missing parts of ribs must be changed.
2. Fit new drive belt to crankshaft pulley.
3. Raise belt tensioner and connect drive belt to steering pump, alternator and compressor pulleys. Ensure drive belt is correctly located in pulley grooves.
4. Position engine mounting front bracket to engine front plate and tighten bolts to 45 Nm (33 lbf ft).
5. Fit top arm. 12.45.06 Arm Assembly-Engine Mounting RH
6. Connect battery earth lead.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
