Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
Steering Box Centralization: Adjust
- Slacken drag link adjuster clamp nuts and bolts.
- Rotate adjuster to align steering box. Recheck steering box alignment.
- Tighten adjuster clamps to 8mm, 22 Nm (16 ft. lbs.), 10mm, 47 Nm, (35 ft. lbs.).
- Check steering wheel for correct alignment. If necessary, remove wheel and centralize.
CAUTION:
Ensure adjuster clamp nuts and bolts are positioned clear of drop arm.
CAUTION:
Repositioning of the steering wheel on its splines cannot correct small (less than 5Β°) errors in steering wheel alignment. Always rectify small errors in alignment by adjusting the drag link as detailed above, ensuring that steering box centralization is maintained.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
