Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE
Lock Stop Adjust: Adjust
- Raise the vehicle. See JACKING & HOISTINGΒ .
- Slacken LH lock stop locknut. Screw stop bolt clockwise, fully into hub. See Fig 1.
- With assistance, start the engine, turn steering onto right hand lock until resistance is felt.
- With the steering held, unscrew anti-clockwise, stop bolt until it contacts the axle. Screw bolt back in clockwise, by 3 flats.
- Tighten locknut.
- Return steering to center. Turn back to full right hand lock to check adjustment.
- Repeat for RH lock stop.
- Stop engine.
- Remove safety stands. Lower vehicle.
WARNING:
Support on safety stands.
NOTE:
Resistance is created by hydraulic limiter inside steering box.
NOTE:
Resistance should be felt prior to lock stop operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
