2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Procedures: Adjust

  1. Slacken track rod adjuster clamping nuts and bolts. See Fig 1.
  2. Rotate adjuster to give correct alignment.
  3. Roll vehicle backwards and forwards to relieve stresses in steering/front suspension.
  4. Recheck front wheel alignment, taking average of three readings.
  5. CAUTION: Ensure that adjuster clamping nuts and bolts are positioned as shown or wheel rim foul will result
  6. Repeat procedure as necessary to obtain correct alignment.
  7. Tighten track rod adjuster fixings to 8mm, 22Nm (16 ft. lbs.), 10mm, 47Nm, (35 ft. lbs.).
Fig 1: Adjusting Toe-In
G00016393Courtesy of LAND ROVER NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.