2002 Land Rover Range RoverFACTORY OEM SERVICE PROCEDURE

DSC System Warning Lamps

Fig 1: DSC System Warning Lamps
G00523147Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  1. HDC lamp
  2. Brake warning lamp
  3. Brake assist/brake warning lamp
  4. ABS warning lamp
  5. DSC warning/information lamp

The following table describes the warning lamps, their associated faults and system response.

System Status Hand Brake Warning Lamp Brake Warning Lamp ABS Lamp DSC Lamp HDC Lamp Message Centre
Lamp check On for 2 seconds Amber for 1 second then red for 1 second On for 2 seconds On for 2 seconds On for 2 seconds  
ECU under voltage   On, red and amber On On Off  
Hand brake On On, red         Release park brake (when driving)
Low brake fluid level   On, red       Check brake fluid
Electric Brake Assist (EBA) failure) ABS & EBD available)   On, amber Off    
ABS Failure (EBD available)   On, amber On On Off  
EBD failure   On, amber, or red On On Off  
DSC failure   On, amber, or red   On On Single gong 1st time failure occurs
HDC failure   On, amber or red   On Off HDC Inactive
DSC activity (including engine intervention)       flash 2 Hz    
ETC activity (brakes only)            
DSC switched passive (TC function still available)       On  
ETC activity while DSC switched passive       On    
HDC switched on (not enabled or fading out)       On    
HDC switched on and enabled         flash 2 Hz  
HDC switched on and enabled         On  
HDC temporarily unavailable (brake overheat)         Off HDC temp. Not available
HDC switching off (due to high speed in high range)         Off No HDC - slow down
Driver attempt to switch on HDC at high speed in high range         Off No HDC - slow down
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.