2002 Land Rover Freelander SFACTORY OEM SERVICE PROCEDURE

Wheel Alignment Procedure: Front: Adjusting

  1. Mark position of steering ball joints for reference. Loosen track rod and ball joint pinch bolts. See Fig 1 .
  2. CAUTION: Both track rods must be rotated an equal amount.
  3. Rotate turnbuckle to obtain correct alignment. Ensure ball joint is not rotated.
  4. Recheck front wheel alignment. See WHEEL ALIGNMENT SPECIFICATIONSΒ  .
  5. Ensure slots in turnbuckle clamps are aligned. See Fig 2 .
  6. Tighten track rod and ball joint pinch bolts to 28 Nm (21 lbs. ft.).
Fig 1: Adjusting Front Alignment
G00368346Courtesy of LAND ROVER NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.