2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE

Tailgate Window Regulator: Service and Repair


Glass Regulator - Tail Door

Service Repair No - 76.81.18


Remove
1. Remove rear screen.

Factory service manual diagram




2. Disconnect multiplug from regulator motor.

Factory service manual diagram




3. Loosen 3 nuts securing regulator motor and rotate motor to release from door.
4. Loosen 4 nuts securing top of cable guides and release guides from door.
5. Remove 2 nuts securing pre-load adjusters and rotate adjusters fully clockwise to improve access.
6. Release regulator from door and detach electrical harness from LH glass clamp.
7. Remove regulator from door.

Refit
1. Position regulator to door and unclip motor transit package from rail.
2. Connect multiplug to regulator motor.
3. Connect harness clip and align regulator to door.
4. Fit nuts to pre-load adjusters, but do not tighten at this stage.
5. Position tops of cable guides to door, leaving fixings finger tight.
6. Tighten regulator motor fixings.
7. Fit rear screen.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.