Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Control Module: Service and Repair
ECU
Remove

1. Loosen 5 screws and remove 'E'- box lid.

2. Release 2 retainers and withdraw ECU.
3. Disconnect multiplug from ECU and remove ECU.
Refit
1. Connect multiplug to ECU.
2. Locate and secure ECU.
3. Fit 'E'- box lid and tighten screws.
Remove
1. Loosen 5 screws and remove 'E'- box lid.
2. Release 2 retainers and withdraw ECU.
3. Disconnect multiplug from ECU and remove ECU.
Refit
1. Connect multiplug to ECU.
2. Locate and secure ECU.
3. Fit 'E'- box lid and tighten screws.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
