2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE

Spark Plug: Service and Repair


Spark Plugs

Service Repair No - 18.20.02

Remove
1. Disconnect battery earth lead.
2. Remove engine acoustic cover.


Factory service manual diagram





3. RH bank only: Release locking clips and disconnect multiplugs from plug top coils.
4. RH bank only: Remove 6 bolts securing plug top coils to RH camshaft cover and remove coils.


Factory service manual diagram





5. LH bank only: Noting their fitted positions, disconnect ht leads.
6. Using a 16 mm plug socket, remove spark plugs from both cylinder heads.

Refit
1. Set gap of each new spark plug to 1.00 mm.
2. Fit spark plugs and tighten to 25 Nm (18 ft. lbs.).
3. LH bank only: Connect ht leads.
4. RH bank only: Fit plug top coils to spark plugs.
5. RH bank only: Fit bolts securing plug top coils to RH camshaft cover and tighten to 9 Nm (6.5 ft. lbs.).
6. RH bank only: Connect multiplugs to plug top coils and secure with locking clips.
7. Fit engine acoustic cover.
8. Connect battery earth lead.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.