Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Sensor - Throttle Position (TP) - NAS
Sensor - Throttle Position (TP) - NAS
Service Repair No - 19.22.49
Remove
1. Disconnect battery earth lead.
2. Remove 2 nuts and release throttle pedal from studs.
3. Release TP sensor multiplug from bracket and disconnect from main harness.
4. Remove nut and release lever from sensor.
5. Remove 2 nuts and bolts and remove sensor.
Refit
1. Fit TP sensor and tighten nuts and bolts to 10 Nm (7 ft. lbs.).
2. With throttle pedal held closed, fit lever to sensor and tighten nut to 10 Nm (7 ft. lbs.).
3. Position throttle pedal, connect multiplug and secure to pedal bracket.
4. Fit pedal to studs and tighten nuts to 25 Nm (18 ft. lbs.).
5. Connect battery earth lead.
6. Use TestBook to confirm correct operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
