2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE

General Specifications


General Specifications

Type Pin-Slider Caliper with Ventilated Disc, Self-Adjusting
Disc Diameter 262 mm (10.31 in.)
Disc Thickness:
New 20.8 - 21.00 mm (0.818 in. - 0.826 in.)
Service Limit 18.00 mm (0.708 in.)
Disc Runout (max) 0.040 mm (0.0016 in.) with wheel on
Pad Minimum Thickness 3.00 mm (0.118 in.)

Rear Drum Brakes
Drum Inside Diameter 254 mm (10.00 in.)
Drum Wear Limit 255.49 mm (10.059 in.) discard drum
Lining Minimum Thickness 2.00 mm (0.079 in.)
Drum Ovality Limit 0.012 mm (0.0005 in.)

Master Cylinder
Bore Diameter 23.80 mm (0.937 in.)

Brake Servo
Servo Boost Ratio 4.5 : 1

Parking Brake
Type Mechanically Operated via Twin Cables on Rear Drum Brakes

Anti-Lock Braking System
Circuit Type Diagonal Split, Dual Circuit, 4-Sensor ABS
ABS Type:
TEVES MK20 with ABS, Hill Descent Control (HDC), Electronic Traction Control (ETC) and Electronic Brakeforce Distribution (EBD).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.