Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Tailgate: Service and Repair
76.28.19.99 Door - Tail Assembly - Remove For Access & Refit
Remove
1. Remove spare wheel from tail door.
2. Remove RH rear quarter lower trim casing.
3. Release and disconnect 3 multiplugs and rear washer tube from lower 'E' post.
4. Remove 2 bolts from tail door check strap, release strap and position aside.
5. Release door harness sheath from 'E' post and pull harness through 'E' post.
6. Mark position of hinges.
7. Support weight of tail door.
8. Remove 6 bolts securing tail door hinges to body and with assistance, remove tail door.
Refit
1. With assistance position door. Fit securing bolts but do not tighten at this stage.
2. Position check strap and secure with bolts.
3. Align hinges and tighten bolts to 30 Nm (22 lbf.ft).
4. Feed door harness through 'E' post and secure harness sheath.
5. Connect and secure multiplugs and rear washer tube at 'E' post.
6. Fit rear quarter lower casing.
7. Fit spare wheel to tail door.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
