Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Mirrors: Service and Repair
76.10.57 Mirror - Exterior - Electric
Remove
1. Remove cheater panel.
2. Up to 04MY: Disconnect 2 Lucars from tweeter and place cheater panel aside.From 04MY: Disconnect multiplug from tweeter and position cheater panel aside.
3. Disconnect multiplug from mirror.
4. Support mirror and remove 2 Torx screws. From 04MY: Remove additional Torx screw.
5. Remove exterior mirror.
6. Collect clamping plate.
Refit
1. Position mirror, locate clamping plate, fit and tighten Torx screws to 6 Nm (4.5 lbf.ft).
2. Connect multiplug to mirror.
3. 04MY: Connect multiplug to tweeter.
4. Connect Lucars to tweeter in cheater panel.
5. Fit cheater panel to door.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
