Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Front Cross-Member: Service and Repair
Rear Beam
Remove
1. Remove underbelly panel.
2. Remove bolt securing engine lower steady to beam.
3. Remove 4 bolts securing anti-roll bar saddle clamps to beam.
4. Support anti-roll bar.
5. Loosen nuts securing lower arm rear mountings.
6. Remove 2 bolts securing each lower arm rear bush housing.
7. Remove lower arm pivot bush bolts.
8. Release lower arms from beam.
9. Support beam and remove 2 remaining bolts securing beam.
10. Lower and remove beam.
Refit
1. Position and align beam, fit new bolts securing beam to body but do not fully tighten at this stage.
2. Locate lower arm bushes, fit but do not fully tighten bolts.
CAUTION: Nuts and bolts must be tightened with weight of vehicle on suspension.
3. Clean bush housing and mating faces on beam.
4. Align bush housings ensuring roll pin is correctly located. Fit bolts and tighten to 105 Nm (77 ft. lbs.).
5. Tighten bolts securing beam to body to 190 Nm (140 ft. lbs.).
6. Fit saddle clamp bolts and tighten to 23 Nm (17 ft. lbs.).
7. Align engine lower steady, fit bolt and tighten to 100 Nm (74 ft. lbs.).
8. Lower vehicle.
9. Tighten lower arm front bush bolts to 190 Nm (140 ft. lbs.).
10. Tighten lower arm rear bush nuts to 140 Nm (103 ft. lbs.).
11. Fit underbelly panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
