Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Land Rover Freelander (LN) V6-2.5LFACTORY OEM SERVICE PROCEDURE
Front Fender: Service and Repair
76.10.24 Wing - Front
Remove
1. Remove front mud flap.
2. Remove lower sill finisher.
3. Remove 4 bolts securing rear of front wing.
4. Release wheel arch liner from rear of front wing.
5. Remove 2 bolts securing wing bracket to 'A' post.
6. Remove 4 bolts securing top of wing.
7. Remove bolt securing front of wing to bracket on body.
8. Remove screw securing wheelarch liner to under side of wing.
9. Release wing from body and disconnect multiplug from repeater lamp.
10. Remove front wing from body.
11. Remove side repeater lamp from front wing.
Refit
1. Fit side repeater lamp to front wing.
2. Position front wing to body.
3. Connect repeater lamp multiplug.
4. Align front wing to body.
5. Fit bolts securing rear wing to 'A' post, top of wing and front of wing, but do not tighten at this stage.
6. Align wing and tighten bolts in sequence shown to 5 Nm (3.5 lbf.ft).
7. Align wheel arch liner to rear of wing.
8. Fit screw securing wheel arch liner to under side of wing.
9. Fit lower sill finisher.
10. Fit front mud flap.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
