Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2001 Land Rover Range Rover SEFACTORY OEM SERVICE PROCEDURE
EVAP System Pressure Test Drive Cycle
- Switch ignition on for 30 seconds. Ensure engine coolant temperature is less than 140°F (60°C). Start the engine and allow to idle for 2 minutes.
- Perform 2 light accelerations, 0-35 mph, with light pedal pressure. Perform 2 medium accelerations, 0-45 mph, with moderate pedal pressure. Perform 2 hard accelerations, 0-55 mph, with heavy pedal pressure.
- Increase speed to 60 mph and cruise for 8 minutes. Decrease speed to 50 mph and cruise for 3 minutes. Allow engine to idle for 3 minutes. Connect Testbook and check for DTCs.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.