2001 Land Rover Range Rover HSEFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor

NOTE: Because ECM is able to determine the closed throttle position, the TP sensor does not need to be adjusted when replaced.
  1. Check for poor connections, loose terminals, and open or shorted wires. See WIRING DIAGRAMS article. If no problems are found, go to next step. Perform repairs as necessary.
  2. Turn ignition on. Backprobe between ECM 52-pin connector C0636 terminals No. 24 (Yellow/Light Green wire) and No. 25 (Red/Black wire). Measure voltage while moving throttle valve between fully closed (idle) and fully open (wide open) positions. See THROTTLE POSITION SENSOR SIGNAL VOLTAGEΒ  table. If voltage is as specified and changes smoothly, test is complete. If voltage is not as specified, replace TP sensor.
THROTTLE POSITION SENSOR SIGNAL VOLTAGE

Position Volts
Minimum Zero
Idle 0.3-0.5
Wide Open Throttle (WOT) 4.5
Maximum 5.0
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.