2000 Land Rover Range Rover SEFACTORY OEM SERVICE PROCEDURE

Power Circuits (Discovery Series II)

  1. Turn ignition off. Using a backprobe set, check for voltage between ground and ECM Black 9-pin connector C0634 terminal No. 7 (Purple/Yellow wire). If battery voltage is present, go to next step. If battery voltage is not present, check for open or short in Purple/Yellow wire between ECM and fuse No. 12 (20-amp) located in engine compartment fuse/relay box. See Figure and Figure . See WIRING DIAGRAMSΒ . Perform repairs as necessary.
  2. Turn ignition off. Using a backprobe set, measure voltage between ground and ECM Black 24-pin connector C0635 terminal No. 23 (Blue/Red wire). See WIRING DIAGRAMSΒ . If battery voltage does not exist, ensure inertia switch is closed. If necessary, reset inertia switch and recheck for voltage. If inertia switch is closed, check circuit between ECM, main relay, inertia switch and fuse No. 13 (15-amp), located in engine compartment fuse/relay box. Perform repairs as necessary.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.