2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Engine Oil Cooler Pipe Unions 22 (30)
Front Exhaust Pipe-To-Exhaust Manifold Nuts 37 (50)
Front Exhaust Pipe-To-Intermediate Pipe Nuts 18 (25)
Rear Drive Shaft-To-Transfer Box Flange Bolts & Nuts (1) 35 (48)
Snubber Bar-To-Crossmember Forward Bolts 33 (45)
Transmission Fluid Cooler Pipe Unions 16 (22)
Transmission Mount Bolts 33 (54)
INCH Lbs. (N.m)Β 
Lock-Up Solenoid Torx Screws 71 (8.0)
Pressure Regulator Torx Screws 71 (8.0)
Shift Control Selector Cover 11 (1.6)
Shift Control Solenoid Torx Screws 71 (8.0)
Speed Sensor Retaining Bracket Screws 71 (8.0)
Transfer Case Drain & Fill/Level Plug 22 (30)
Transmission Drain Plug 11 (15)
Transmission Fill/Level Plug 22 (30)
Transmission Fluid Filter Bolts 71 (8.0)
Transmission Fluid Pan Bolts 71 (8.0)
Transmission Fluid Pick-Up Tube Bolt 71 (8.0)
Transmission Pan Bolt 71 (8)
(1) Install NEW nuts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.