Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE
Component Locations
COMPONENT LOCATIONS
| Component | (1) Location | ||
|---|---|---|---|
| Auto Gear Box Control Unit | Under Left Front Seat | ||
| Body Electrical Control Module & Fuse Box | Under Right Front Seat | ||
| Engine Coolant Temperature Sensor | Left Side Of Engine | ||
| Engine Control Module (ECM) | At Left Rear Corner Of Engine Compartment | ||
| Gear Box Position Switch | Left Side Of Transmission | ||
| "H" Gate Sensor Module | In Center Console | ||
| Throttle Position Sensor | On Throttle Body | ||
| Transfer Gear Box ECU | In Center Console | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
