Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Land Rover Range Rover BaseFACTORY OEM SERVICE PROCEDURE
Section 4 (Anti-Lock/Traction Control): Description
WARNING: This page is about a different car, the 2000 Land Rover Discovery and 1999 Land Rover Discovery. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Discovery and Discovery II can be identified by VIN number. The 4th and 5th digits of the VIN are JY on Discovery, TY on Discovery II. This article applies to Discovery II. For information on Discovery, see ANTI-LOCK - DISCOVERY
article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
