2000 Land Rover DiscoveryFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Drag Link-To-Drop Arm 59 (80)
Track Rod-To-Steering Knuckle 92 (125)
Steering Damper 92 (125)
Steering Knuckle-To-Axle Yoke Upper Ball Joint 81 (110)
High Pressure Pipe Union 15 (20)
Drag Link/Track Rod M8 Bolts 16 (22)
Drag Link/Track Rod M10 Bolts 24 (33)
Steering Box 66 (90)
Universal Joint-To-Intermediate Shaft 18 (25)
Panhard Rod 170 (230)
Steering Box Output Shaft 65 (88)
Drop Arm 177 (240)
Auxiliary Housing Bolts 30 (40)
PAS Pump - V8 16 (22)
PAS Pump Pipe Bracket Bolt 16 (22)
Jockey Pulley Bolt 37 (50)
PAS Pump-To-Coolant Pump Bolts - Td5 18 (25)
Steering Column-To-Fascia 18 (25)
Universal Joint-To-Steering Box 18 (25)
Ball Joint-To-Swivel Hub 57 (77)
PAS Pump Pulley 16 (22)
Steering Wheel Nut 32 (43)
INCH Lbs. (N.m)Β 
Auxiliary Housing Nut 89 (10)
PAS Pump Adaptor Pipe 89 (10)
Tension Collet-To-Steering Knuckle 44 (5)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.