Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Land Rover Defender 90 AutomaticFACTORY OEM SERVICE PROCEDURE
Toe Adjustment: Defender
- Roll vehicle backwards and forwards to settle linkage. Install alignment equipment according to manufacturer's instructions. Check toe adjustment. See WHEEL ALIGNMENT SPECIFICATIONΒ table. If toe adjustment is not within specification, go to next step. If toe adjustment is within specification, ensure track rod clamp bolts are tightened to 10 ft. lbs. (14 N.m).
- Loosen clamp bolts at both ends of track rod. See Fig 1. Rotate track rod to increase or decrease toe adjustment. When toe adjustment is completed, push vehicle backwards turning steering wheel from side-to-side to settle linkage. Set wheels to a straight-ahead position and push vehicle forward to original position.
- Recheck toe adjustment and correct as necessary. Turn steering wheel from lock-to-lock and ensure there is full, unrestricted movement of track rod. Tap the side of the track rod ends to ensure unrestricted movement of track rod. Tighten track rod clamp bolts to 10 ft. lbs. (14 N.m). Road test vehicle over an even surface. Ensure steering wheel alignment is okay and vehicle tracks straight. If steering wheel is not straight, see CENTERING STEERING WHEELΒ .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
