1997 Land Rover Defender 90 AutomaticFACTORY OEM SERVICE PROCEDURE

Main Relay

Main relay is part of relay module located at left side of engine compartment. See Fig 1 , Fig 2 or Fig 3 .

The main relay supplies power to the ECM, fuel injectors (8 amps) and Mass Airflow (MAF) sensor (4 amps). Relay is controlled by the ECM which has a second power feed. This enables the ECM to remain powered up after the ignition is turned off. During ECM power down, the ECM records all temperature readings and powers the IAC to the cold start position. Failure of this relay will result in the ECM not being powered up, resulting in engine not starting due to absence of fuel and ignition.

NOTE: Components are grouped into 2 categories. The first category covers INPUT DEVICES, which control or produce voltage signals monitored by the PCM. The second category covers OUTPUT SIGNALS, which are components controlled by the PCM.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.