1995 Land Rover Defender 90FACTORY OEM SERVICE PROCEDURE

Test 2

  1. Switch the ignition ON (engine off). Connect voltmeter to points in the circuit indicated by V1 to V4 and make a note of the voltage readings. See Fig 1 . Readings for V1 should be more than 12 volts. Readings for V2 should be 1 volt maximum below volts at V1. Readings for V3 should be 1 volt maximum below volts at V1. Readings for V4 should be 0.0-0.1 volt.
    Fig 1: Testing Ignition Coil Voltage
    G00109152Courtesy of LAND ROVER NORTH AMERICA, INC.
  2. If all readings are correct, proceed to TEST 3Β  . If readings are incorrect, see Fig 2 . If coil and amplifier is suspected, disconnect low tension lead at coil, repeat V3. If voltage is still incorrect, fit new coil. If voltage is now correct, check low tension lead, if satisfactory fit new amplifier. If engine will not start proceed to TEST 3Β  .
    Fig 2: Diagnosing Ignition Coil Voltage
    G00109157Courtesy of LAND ROVER NORTH AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.