2025 Kia Soul EXFACTORY OEM SERVICE PROCEDURE

Description And Operation: Description: Self-Diagnosis

  • When the ECM detects an irregularity, it records the diagnostic trouble code, and outputs the signal to the Data Link connector.
  • DTC codes are not deleted even if IG OFF.

InformationΒ 

  • Low battery voltage can degrade self-diagnosis and the malfunction cannot be detected, so check the battery voltage and other conditions before inspection.
  • If a sensor or actuator connector is disconnected with the IG turned on, the diagnostic trouble code (DTC) is recorded. In this case, disconnect the battery negative terminal (-) for 15 seconds or more, and the diagnosis memory will be erased.
  • DTC code can be deleted by disconnecting the battery terminal when deleting the DTC code, but in this case, the learning data inside the ECM is also deleted at the same time. Therefore, KDS should be used.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.