Information

Perform inspecting procedure by with the KDS as shown in the illustration below.

Courtesy of KIA MOTORS AMERICA, INC.

Perform the procedures below by with the KDS when replacing the Engine Control Module (ECM) with a reused one.
1. Perform the resetting adaptive values.
  (S/W Management → Engine Control → Resetting Adaptive Values)
2. Perform the immobilizer neutral mode/smart key neutralization mode.
  - Non-Smart Key type
    (S/W Management → Immobilizer → Neutral Mode)
  - Smart Key type
  (S/W Management → Smart Key Unit → Neutralization Mode)
3. Perform the auto detected configuration reset.
(S/W Management → Engine Control → Auto Detected Configuration Reset)
Perform the "Key Teaching" procedure with the KDS.
- Non-Smart Key type
  (S/W Management → Immobilizer → LEARNT KEYS)
- Smart Key type
Turn IG ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
Perform the VIN writing procedure with the KDS.
(S/W Management → Engine Control → Write VIN)

Information

Refer to the KDS screen for operating conditions and details.
Perform ETC module learning procedure
(Refer to Electronic Throttle Control System - "ADJUSTMENT ")

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Engine Control Module (ECM): Adjustment