Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2025 Kia Seltos X-LineFACTORY OEM SERVICE PROCEDURE
On Vehicle Inspection
- Disconnect the battery negative (-) terminal.
- Remove the engine cover.
(Refer to Engine Mechanical System - " ENGINE COVER ")
- Measure the resistance between terminals after disconnecting the Oil Control Valve (OCV) connector (A).
Intake
Exhaust
- Check that the resistance is within the specification.
Item Specification Coil resistance (MΩ) Minimum 1 [@500 VAC, 20°C (68°F)]
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.