Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Telluride SX X-LineFACTORY OEM SERVICE PROCEDURE
ETC (Electronic Throttle Control) System: Cleaning
- Remove the Electronic Throttle Control (ETC) module.
(Refer to ETC (Electronic Throttle Control) System - "REMOVAL AND INSTALLATION ")
NOTE: Cleaning the ETC module after removing it. - Using a cleaner and soft cloth to clean the contaminated area inside the throttle body.NOTE:
- Be careful not to get foreign matter into the ETC.
- Do not spray cleaning fluid to ETC directly and use a lint free cloth moistened with throttle cleaning fluid.
- Be careful as fingers or cloth may get caught in the valve.
- Be careful not to wipe the coating liquid (displayed area) around the shaft. If the coating liquid is removed, a poor idle control may occur due to the inflow of foreign matters into the shaft inner bearing and an excessive amount of air leaking.
- Install the ETC module.
(Refer to ETC (Electronic Throttle Control) System - "REMOVAL AND INSTALLATION ")
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.