Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE
Cluster Module DTCS
CLUSTER MODULE DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1000-51 | Cluster Coding Not Programmed |
| B1001-52 | SCC Missing Error - without SCC unit or connector fault |
| B1001-55 | SCC Present Error - Coding code error |
| B1002-52 | EPB Missing Error - without EPB unit or connector fault |
| B1002-55 | EPB Present Error - Coding code error |
| B1003-52 | ABS Missing Error - without ABS unit or connector fault |
| B1003-55 | ABS Present Error - Coding code error |
| B1005-52 | Airbag Missing Error - without Airbag unit or connector fault |
| B1005-55 | Airbag Present Error - Coding code error |
| B1008-52 | MDPS Missing Error - without MDPS unit or connector fault |
| B1008-55 | MDPS Present Error - Coding code error |
| B1009-52 | 4WD Missing Error - without 4WDD unit or connector fault |
| B1009-55 | 4WD Present Error - Coding code error |
| B1010-52 | ESC Missing Error - without ESC unit or connector fault |
| B1010-55 | ESC Present Error - Coding code error |
| B1020-52 | TPMS Missing Error - without TPMS unit or connector fault |
| B1020-55 | TPMS Present Error - Coding code error |
| B1040-52 | LKA Missing Error |
| B1040-55 | LKA Present Error |
| B2800-00 | MM CAN Bus Off Error |
| B2801-00 | MM CAN Signal Line Error |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.