Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE
Engine Control System Diagnosis (04 Of 13)
- DTC P0132-00: O2 Sensor Circuit High Voltage (Bank 1/Sensor 1)
- DTC P0133-00: O2-Sensor Circuit Slow Response (Bank 1/Sensor 1)
- DTC P0135-00: O2 Sensor Heater Circuit (Bank 1/Sensor 1)
- DTC P0136-00: O2 Sensor Circuit (Bank 1/Sensor 2)
- DTC P0137-00: O2 Sensor Circuit Low Voltage (Bank 1/Sensor 2)
- DTC P0138-00: O2 Sensor Circuit High Voltage (Bank 1/Sensor 2)
- DTC P0139-00: O2 Sensor Circuit Slow Response (Bank 1/Sensor 2)
- DTC P0140-00: O2 Sensor Circuit No Activity Detected (Bank 1/Sensor 2)
- DTC P0151-00: O2 Sensor Circuit Low Voltage (Bank 2/Sensor 1)
- DTC P0152-00: O2 Sensor Circuit High Voltage (Bank 2/Sensor 1)
- DTC P0153-00: O2 Sensor Circuit Slow Response (Bank 2/Sensor 1)
- DTC P0155-00: O2 Sensor Heater Circuit (Bank 2 Sensor1)
- DTC P0156-00: O2 Sensor Circuit (Bank 2/Sensor 2)
- DTC P0157-00: O2 Sensor Circuit Low Voltage (Bank 2/Sensor 2)
- DTC P0158-00: O2 Sensor Circuit High Voltage (Bank 2/Sensor 2)
- DTC P0159-00: O2 Sensor Circuit Slow Response (Bank 2/Sensor 2)
- DTC P0160-00: O2 Sensor Circuit No Activity Detected (Bank 2/Sensor 2)
- DTC P0171-00: System Too Lean (Bank 1)
- DTC P0172-00: System Too Rich (Bank 1)
- DTC P0174-00: System Too Lean (Bank 2)
- DTC P0175-00: System Too Rich (Bank 2)
- DTC P0191-00: Fuel Rail Pressure Sensor Circuit Range/Performance
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
