Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Seltos X-LineFACTORY OEM SERVICE PROCEDURE
Speed Sensor: Installation
- Install in reverse order of removal.NOTE:
- When installing the valve body, make sure that the pin (B) of the manual valve is inserted into the detent lever (A).
- Lubricate the oil temperature sensor O-ring (A) before installing the E module.
- When installing, after mounting the E module, lightly tap the connector part (A) to insert the connector certainly and then tighten the bolts.
- The existing valve body cover gasket (A) must be replaced with a new one (do not reuse).
- When installing the valve body cover, tighten the remaining bolt after pre-tightening the bolt (A).
- When installing the valve body, make sure that the pin (B) of the manual valve is inserted into the detent lever (A).
- Replenish the automatic transaxle fluid.
(Refer to " HYDRAULIC SYSTEM - FLUID ")
- Check for leakage of coolant or fluid from hose connection while the engine is starting and running.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.