Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Seltos X-LineFACTORY OEM SERVICE PROCEDURE
Front Radar System DTCS
FRONT RADAR SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| C1101-17 | Battery Voltage High |
| C1102-16 | Battery Voltage Low |
| C1202-81 | Wheel Speed Sensor Front-LH Invalid/No Signal |
| C1205-81 | Wheel Speed Sensor Front-RH Invalid/no Signal |
| C1208-81 | Wheel Speed Sensor Rear-LH Invalid/no Signal |
| C1211-81 | Wheel Speed Sensor Rear-RH Invalid/no Signal |
| C1260-81 | Steering Angle Sensor Circuit - Signal |
| C1260-82 | Steering Angle Sensor Circuit - signal |
| C1260-83 | Steering Angle Sensor Circuit - signal |
| C1283-81 | Lateral G Sensor/Longitudinal G Sensor/Yaw Rate Sensor - Signal Error |
| C1360-81 | ESP Irreversible Error |
| C1604-04 | ECU Hardware Error |
| C160A-88 | Local CAN Bus OFF |
| C160C-87 | Local CAN Time-Out |
| C1611-87 | CAN Time-out EMS |
| C1612-87 | CAN Time-out TCU |
| C1613-08 | CAN Signal Error EMS |
| C1613-81 | CAN Signal Error EMS |
| C1613-82 | CAN Signal Error EMS |
| C1613-83 | CAN Signal Error EMS |
| C1616-88 | C-CAN Bus OFF |
| C1620-78 | Alignment Failed |
| C1623-87 | CAN Time-Out Steering Angle Sensor |
| C1625-87 | CAN Time-Out ABS/ESP |
| C1628-87 | CAN Time-Out Cluster |
| C1629-82 | Cluster Invalid Counter |
| C1632-81 | Cluster Control Switch Fail |
| C1633-81 | Cluster Invalid Displayed Speed |
| C1638-81 | SCC Communication Error |
| C1642-02 | CAN Message Failure - Brake |
| C1642-81 | CAN Message Failure - Brake |
| C1642-82 | CAN Message Failure - Brake |
| C1642-83 | CAN Message Failure - Brake |
| C1646-81 | CAN Message Failure - TCU |
| C16B8-81 | FCA Communication Error |
| C1702-55 | Variant Coding Error |
| C1741-81 | ESC-not available VSM (Check ESC) |
| C1742-81 | Variant Error - ESC (Check ESC) |
| C1744-55 | SCC Coding & AVN/Navi Option Mismatch |
| C1747-55 | Front Radar & Front View Camera Variant Coding Mismatch |
| C1804-87 | CAN Time-Out LKAS |
| C1805-81 | LKAS CAN Signal Error |
| C1805-82 | LKAS CAN Signal Error |
| C1805-83 | LKAS CAN Signal Error |
| C1812-87 | CAN Time-Out Gateway |
| C1816-87 | CAN Time-Out SJB |
| C1817-82 | CAN Signal Error Gateway |
| C1822-87 | CAN Time-Out NAVI for SCC |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.