Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia Seltos X-LineFACTORY OEM SERVICE PROCEDURE
4WD Control System DTCS
4WD CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P1951-00 | AWD ECU-S/W Fault |
| P1952-00 | AWD ECU-H/W Fault |
| P1953-00 | AWD ECU-Motor Driver Fault |
| P1954-A2 | AWD ECU-Voltage Fault |
| P1954-A3 | AWD ECU-Voltage Fault |
| P1955-11 | AWD Motor-Circuit Fault |
| P1955-12 | AWD Motor-Circuit Fault |
| P1955-13 | AWD Motor-Circuit Fault |
| P1956-11 | AWD Pressure Sensor-Power Line Fault |
| P1956-12 | AWD Pressure Sensor-Power Line Fault |
| P1957-21 | AWD Pressure Sensor-Signal Error |
| P1957-22 | AWD Pressure Sensor-Signal Error |
| P1958-00 | AWD-Torque Error |
| P1959-00 | AWD-Clutch Thermal Stress Too High |
| P1960-00 | AWD-Bleeding Pressure Error |
| P1961-00 | AWD-Install Different Tire Front/Rear |
| P1962-00 | AWD-Unmatching Vehicle CAN Information |
| U0001-88 | High Speed CAN Communication Bus |
| U0100-87 | Lost Communication With ECM/PCM 'A' |
| U0101-87 | Lost Communication With TCM |
| U0122-87 | Lost Communication With Vehicle Dynamics Control Module |
| U0126-87 | Lost Communication With Steering Angle Sensor Module |
| U0127-00 | CLU 13 Error In Communication |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.