Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Steering Column Module (SCM)
- Install in the reverse order of removal.NOTE:
Install to the specified torque.
- Perform the order below with the KDS.
(S/W Management → SCM - Steering Column Module → Steering Limit Position Setting)
Information
Refer to the KDS screen for operating conditions and details
- Perform Over The Air (OTA) controller S/W update with KDS.
(Refer to Body - " OVER THE AIR (OTA) ")
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.