2024 Kia EV9 GT-LineFACTORY OEM SERVICE PROCEDURE

Description And Operation: Description: Function

  1. Manual Operating
    • Tilt and telescopic control by operating the manual switch.
    • When the manual switch signal is input, the relay is activated to change the steering column position.
  2. Memory
    • It memorizes and operates the tilt and telescopic positions of 2 drivers.
    • When the driver operates the IMS switch, the stored steering column position is received from the Body Domain Control (BDC) unit via CAN data to operate.
    • Operation by CAN data received when IMS switch input signal.
  3. Door open/close operation: It is the operating function according to driver door OPEN/CLOSE (received CAN data from BDC)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.