Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Kia EV9 GT-LineFACTORY OEM SERVICE PROCEDURE
Side Body Zone Control Module-Driver DTCS
SIDE BODY ZONE CONTROL MODULE-DRIVER DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| B1000-51 | EOL Not Programmed |
| B1603-00 | CAN Bus Off |
| B26EF-00 | Auto Flush Handle Failure SBCM |
| B26F0-00 | LIN BUS Error SBCM |
| B26F2-00 | Charging Door Failure_SBCM |
| B26F3-00 | Charging Door LED Failure_SBCM |
| B26F6-00 | Charging Door Open Detect |
| B26F8-00 | Auto Flush Handle Open Detect |
| B26FA-00 | Outside Mirror Open Detect |
| B26FC-00 | Frunk Latch Failure_SBCM |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.