Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE
Automatic Transaxle System DTCS
AUTOMATIC TRANSAXLE SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION
| DTC | Description |
|---|---|
| P0601-00 | Internal Control Module Memory Check Sum Error |
| P0601-48 | Internal Control Module Memory Check Sum Error |
| P0705-12 | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0705-14 | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0705-1C | Transmission Range Sensor Circuit Malfunction (PRNDL Input) |
| P0706-61 | Transmission Range Sensor Circuit Range/Performance |
| P0706-96 | Transmission Range Sensor Circuit Range/Performance |
| P0711-00 | Transmission Fluid Temperature Sensor 'A' Circuit Range/Performance |
| P0712-00 | Transmission Fluid Temperature Sensor 'A' Circuit Low Input |
| P0713-00 | Transmission Fluid Temperature Sensor 'A' Circuit High Input |
| P0717-00 | Input/Turbine Speed Sensor 'A' Circuit No Signal |
| P0721-00 | Output Speed Sensor Circuit Range/Performance |
| P0722-00 | Output Speed Sensor Circuit No Signal |
| P0729-00 | Gear 6 Incorrect Ratio |
| P0730-00 | Gear 8 Incorrect Ratio |
| P0731-00 | Gear 1 Incorrect Ratio |
| P0732-00 | Gear 2 Incorrect Ratio |
| P0733-00 | Gear 3 Incorrect Ratio |
| P0734-00 | Gear 4 Incorrect Ratio |
| P0735-00 | Gear 5 Incorrect Ratio |
| P0741-00 | Torque Converter Clutch Circuit Performance or Stuck Off |
| P0743-00 | Torque Converter Clutch Circuit Electrical |
| P0748-00 | Pressure Control Solenoid Valve (VFS) 'A' Electrical |
| P0753-00 | Shift Control Solenoid Valve 'A' Electrical (UD/C) |
| P0758-00 | Shift Control Solenoid Valve 'B' Electrical (46/C) |
| P0763-00 | Shift Control Solenoid Valve 'C' Electrical (37R/C) |
| P0768-00 | Shift Control Solenoid Valve 'D' Electrical (OD & LR) |
| P076F-00 | Gear 7 Incorrect Ratio |
| P0773-00 | Shift Control Solenoid Valve 'E' Electrical (28/B) |
| P0791-00 | Intermediate Shaft Speed Sensor 'A' Circuit |
| P0880-00 | TCM Power Input Signal |
| P0955-00 | Auto Shift Manual Mode Circuit |
| P1602-00 | No EOL Data |
| P1C28-00 | OPI Current High |
| P1C2B-00 | OPI Hall Sensor Error |
| P2709-00 | Shift Control Solenoid Valve 'F' Electrical |
| U0001-00 | High Speed CAN Communication Bus |
| U0100-00 | Lost Communication with ECM/PCM 'A' |
| U0287-00 | Lost Communication With Transmission Fluid Pump Module |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.