2023 Kia Telluride EX X-LineFACTORY OEM SERVICE PROCEDURE

4WD Control System DTCS

4WD CONTROL SYSTEM DIAGNOSTIC TROUBLE CODE (DTC) IDENTIFICATION

DTC Description
P0602-41 ECU Internal Error - SW
P0602-47 ECU Internal Error - HW
P0602-49 Motor Driver Error
P1780-16 Battery Voltage Low
P1821-11 Motor Wire Short to Ground
P1821-12 Motor Wire Short to Battery
P1821-13 Motor Wire Open
P1825-11 Pressure Sensor Supply Voltage Low
P1825-12 Pressure Sensor Supply Voltage High
P1827-11 Pressure Sensor Signal Voltage Low
P1827-12 Pressure Sensor Signal Voltage High
P1829-00 Clutch Torque Tolerance Limit Exceed
P1830-00 Clutch Thermal Overstress
P1836-00 Pressure Line Check Error
P3114-00 Vehicle Information Option Not Detected Or Invalid
P3119-00 Front/Rear Tire Difference Too Big or All Wheel Information Missing
U0001-88 High Speed CAN Bus-Off
U0100-87 Lost Communication with EMS
U0101-87 Lost Communication With TCU
U0122-87 Lost Communication With ESC
U0126-87 Lost Communication With MDPS
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.